How to connect iFrog LoRa Gateway to QNAP QIoT Suite Lite

How to connect iFrog LoRa Gateway to QNAP QIoT Suite Lite

In this tutorial, you will learn how to send data from the iFrogLab LoRa Gateway to QNAP QIoT Suite Lite.   Prepare Set up the iFrogLab LoRa USB to QIoT Suite Lite and iFrogLab LoRa Gateway Container. Setup steps can be found at http://www.ifroglab.com/en/?p=6613  (If in Step 10 the expected output is not displayed, using SSH to access the NAS and enter the following commands:            insmod /usr/local/modules/cdc-acm.ko            insmod /usr/local/modules/cp210x.ko            insmod /usr/local/modules/ftdi_sio.ko ) If the NAS…

Read More

How to use an ESP8266 to connect to QNAP QIoT Suite Lite?

How to use an ESP8266 to connect to QNAP QIoT Suite Lite?

  In this tutorial, you will learn how to use MQTT to transmit and receive data to QIoT Suite Lite using an ESP8266. As the ESP8266 has different firmware, specifications and instructions, there are two common methods: ESP826 useing Arduino Core ESP826 useing AT Command combined with Arduino   Ready task (Using Arduino IDE to install the Library and establish IoT Application) 1.  In this example, we use MQTT (for more information, visit https://pubsubclient.knolleary.net/ ). 2. Add a new IoT Application (Refer to “How to show DHT11 data on QIoT…

Read More

If error messages appear when installing AWS Greengrass (After updating QTS Lite from 4.3.3 to 4.3.4)

If error messages appear when installing AWS Greengrass (After updating QTS Lite from 4.3.3 to 4.3.4)

After upgrading QTS Lite from 4.3.3 to 4.3.4, attempting to install AWS Greengress may results in the following  error messages: To reslove this situation, you must remove and reinstall Container Station. To do so, follow these steps: 1. Go to “App Center” , find “Container Station“, click the downwards arrow next to “Open“, and select “Remove“.   2.  Reinstall the “Container Station” and then install “AWS Greengrass“.    

Read More